| 1 |
 |
Using a pen, push contents of Base Gel packet toward tip. |
| |
| 2 |
 |
Using scissors, make 1/4" cut at tip of foil packet. |
| |
| 3 |
 |
Open plastic cone and place in a cup. Squeeze Base Gel into cone using plastic glove, if necessary. |
| |
| 4 |
 |
Using dropper, fill bottle with water to top of sticker. |
| |
| 5 |
 |
Shake until dissolved. Pour contents of bottle into plastic cone. |
| |
| 6 |
 |
Squeeze air out of plastic cone and reseal. |
| |
| 7 |
 |
Massage contents of cone until smooth. |
| |
| 8 |
 |
Using a pen may help to mix all cone contents. |
| |
| 9 |
 |
Using scissors, make 1/8" cut at tip of cone. |
| |
| 10 |
 |
Slowly squeeze Earth Jagua® Gel into bottle. Occasionally tap bottle on counter to settle gel at bottom. |
| |
| 11 |
 |
Twist cap equipped with fine tip onto applicator bottle. |
| |
| 12 |
 |
Cut chosen design from stencil transfer page. |
| |
| 13 |
 |
Use cotton ball to rub eucalyptus oil onto skin. |
| |
| 14 |
 |
Place stencil face-down onto skin. |
| |
| 15 |
 |
Hold in place for 20 seconds. |
| |
| 16 |
 |
Remove stencil. |
| |
| 17 |
 |
Slowly trace stencil outline with Earth Jagua® Gel by squeezing applicator bottle. |
| |
| 18 |
 |
Drying will take about 30–45 minutes. Be careful not to smudge the design! |
| |
| 19 |
 |
Once dry, Gel will be flat and stick to skin. Wait 2–3 hours before removing with warm running water. |
| |
| 20 |
 |
You will see very little color when you first remove the Gel. This is normal. |
| |
| 21 |
 |
Wait 24–48 hours for blue-black color to develop. Enjoy! |
| |
|
(PDF)
|
